spad4

A SPAD for the Whites, Part Two

Inspired by this image from Wings Palette, I decided to give a bit of freehand a try.

Via Wings Palette, a Russian SPAD 7 with a nifty skull-and-bones squadron insignia on the rudder.

My version:

spad4
Skull and crossbones insignia on the rudder, and weathering on the fuselage.

There’s a (nearly) matching skull on the other side of the rudder, of course, although this one turned out better so I’ll have to always remember to photograph this plane heading right! I also used thinned paint and washes to dirty up the fuselage, especially around the nose where the engine and guns make a mess.

I’ve also put a half-inch wood screw up into the belly of the plane, right behind the main landing gear, to serve as an attachment point for a flying stand. There’s two layers of plastic there, from the wing and the body, and the screw seems solid so far, especially with a drop of superglue to lock it in place. I had thought about using a block of wood or blob of milliput inside the fuselage before I assembled it to provide a solid attachment point, but got impatient to assemble the plane! Hopefully the screw will be solid enough as-is, worst case scenario I can always carve a hole in the belly of the plane, stuff the hole with milliput and sculpt a patch.

Up next, one last touchup of the roundels and other paint, then final assembly: cursing the upper wing into place, adding the landing gear and prop disc. That’ll be it, then it’s back to my neglected horde of White & Red infantry who need painting up!

Please Leave a Comment! (Please note that most comments are held for moderation - please be patient!)